Capacity options are 25000, 30000, 35000, 45000, 50000, and 60000 lbs.  Custom sizes and capacities can be special ordered.  Consult factory.  Standard lip is 16".  (lip on 50,000 and 60,000 lb. units is 20".)  WINGGUSSETS (patents pending) on higher capacity units.

35AA Unit Shown
35,000 lb. Capacity Shown

Pit-mounted dock leveler to be (6') (6-1/2') (7') wide, and (6')(8') long with a working range to be from 12" above to 12" below dock level.  Leveler to be hydraulically-operated via push button, remote control box which includes defeatable automatic return to dock mode for automatic recycle of leveler upon departure of carrier, power lip control for for faster lip extension and retraction, and stop control to electrically stop deck motion.  Leveler to minimize time requirement for return to stored position by circumventing full cycle operation through activation of a one-touch push button control.  Control box to be NEMA 12.  Motor to be (see wiring specifications), one horsepower, thermal overload protected.  Leveler lip to positively extend and retract via separate, double-acting hydraulic cylinder during deck lift and to yield under pressure from backing trucks.  Deck cylinder to include drop safe velocity fuse and a front mounted control to adjust descent rate.  Leveler lip and deck to be constructed with high-strength 55000 lb. yield (or better) steel safety tread plate.  Decks with widths of 6' or 6-1/2' to be reinforced with a minimum of 6" I-beams and two 10" plates.  Decks with widths of 7' to be reinforced with a minimum of eight 6" I-beams and two 10" plates.  Leveler to include full range telescoping toe guard on each side, four security night locks, maintenance prop bar, two laminated rubber bumpers, and grease fittings.  Leveler to provide more than 12" of float to allow firm contact with a trailer that is varying in height as its load weight is changed.  Leveler to be painted machine tool gray with safety yellow toe guards.  Leveler to meet or exceed all CS202 and ANSI 14.1 load requirements for ___________ capacity at a time of publication.  Leveler to be "D" SERIES/Hydraulic manufactured by DLM, Inc.